Technical Advisory
How to weld rods
Date 06/05/2019
Stick weldings are an arc process formed at the top of a rod when electricity flows through an air gap (very small) created between the electrode and the solder surface, which says the earth is safe.
Aluminum welding technique with TIG welding machine
Date 06/05/2019
In aluminum welding, you have to understand the process of steps from causing the arc to the end of the arc. On the other hand, you should pay attention to the operation in the torch holder and adjust the metal rod at the appropriate angle.
Overview of Mig / Mag welding methods
Date 06/05/2019
Welding / Magnet welding is a method of GMAW welding using a fire-resisting heat source between the solid wires supplied continuously by an uninterruptible wire feeder. Inert gas (MIG) or activated gas (MAG) protects the lagoon forming this method, also commonly known as semi-automatic welding.
Manual selection of protective gas in MIG welding
Date 06/05/2019
In addition to welding wires, another important factor affecting the quality of the Mig weld is the protection gas.
How to choose equipment, materials and protective equipment in stick welding
Date 06/05/2019
Stick welding is also known as arc welding, are electrodeposition processes using electrodes with or without welding electrodes.
Titanium welding technology
Date 06/05/2019
The method of titanium welding is increasingly favored and widely applied by the aesthetic virtues as well as weld quality.
Everything you need to know in aluminum welding techniques
Date 06/05/2019
During welding, the aluminum solder is prone to burn the material if the welders work incorrectly due to the high thermal conductivity and low melting point of aluminum compared to other metals.
Welding rod technique: arc-inducing and finishing technique
Date 06/05/2019
In stick welding, the technique is essentially the operators manipulation of the arc and the arc. Weld positions may be different, but the general purpose is to provide the most durable and aesthetic link.
Types of welding distortion and measures to reduce welding distortions
Date 06/05/2019
Distortions or warping are occurring due to uneven shrinkage between the base metal of the weld and the base metal during heating and cooling during welding and after welding.